| New Parts !! |
| Page: |1| 2 3 4 5 ...21 | ||
|
| |||||
 | NOW AVAILABLE, NEW REPRODUCTION FINISHED AT LAST!!!! | ||||
| |||||
| |||||
 | |||||
| |||||
| |||||
 | Original arm rest was often only on the driver side. it was attached with clips that went into rectangular holes, this is the clip. Clip goes into the rectangular hole. | ||||
| |||||
| |||||
 | made in USA | ||||
| |||||
| |||||
 | |||||
| |||||
| |||||
 | Pour formed for perfect fit. Self adhesive backing. No more old sticky, gummy, gook. Solid, smooth, high tech for a perfect level floor. This kit is included in the complete floor kit below and the complete insulation kit at bottom of page.. | ||||
| |||||
| |||||
 | |||||
| |||||
| |||||
 | made in USA Many of our customers needed just one or two, so we broke down the set and sell as each piece, same price per piece. | ||||
| |||||
| |||||
 | made in USAPolished, neat! | ||||
| |||||
| |||||
 | Leave black or paint, perfect fit, easy install, pre-drilled with clips for fan. 1 1/2" deep. comes with clips to mount fan directly to shroud (use 82313-SS bolt kit, needs 10-24 bolts) | ||||
| |||||
| |||||
 | This is the stuff I have found I like best, it does not have the aluminum covering. If you want aluminum look at 2166, if not check this one out. To get best results with aluminum it has to be just exactly the right stuff and half the time we are not using it correctly. This stuff adheres nicely and does the best job I have found with vibration reduction, it sticks so well and stays where you put it, I hate when insulation falls away from the steel. When installing this do not be afraid of the heat gun, place it where you want it, get the stuff good and hot and roll it down, if it comes away from the metal, either you did not clean good enough (dust) or go back and heat it again. | ||||
| |||||
| |||||
 | SALE ON THESE, This cover is Sy's pattern so fits better than any other cover on the market and is reinforced at the tailgate points. Now we have made a better deal to have them made, better prices!!!!!! | ||||
| |||||
| |||||
 | Sy's latest design, could NOT get any covers that fit the way I wanted them, so finally found a manufacture that would make covers exactly by my pattern. AND this one even has a driver door zipper, oh-so handy. SALE ON THESE, This cover is Sy's pattern so fits better than any other cover on the market and is reinforced at the tailgate points. Now we have made a better deal to have them made, better prices!!!!!! (this one, with the door zipper, is out of stock until about May but we will honor the sale price and even offer Free shipping to anyone on the waiting list.) | ||||
| |||||
| |||||
 | we are so excited to finally get this finished, tiny bug has been in process for years! | ||||
| |||||
| |||||
 | Expensive to produce, check for internal ball, without it this will not work. Note the upper outlet goes to the spray head, the lower, larger outlet goes to the pump. This fitting goes on either the Jar Lid or the Bag lid. Fits most other cars of the era as well. | ||||
| |||||
| Page: |1| 2 3 4 5 ...21 |
Showing 1 - 15 of 313 Products
© 2012 Mid Fifty F-100 Parts - Site created by Gaffney Designs